Use and Care Manual

• Loud 85 decibel alarm.

• Permanent independent smoke and carbon monoxide sensors.

• Smoke alarm takes precedence when both smoke and

carbon monoxide are present.

• Powered by 120V AC (60 Hz, 7.5mA max) wire-in connector

and sealed 3V Lithium battery backup.

• Interconnectable to other Kidde/Nighthawk brand smoke and

CO alarms (see page 15 for details).

• Alarm/Voice message warning system that alerts you of the

following conditions in the manner described below, thus

eliminating any confusion over which alarm is sounding:

FIRE: The alarm/voice pattern is three long alarm beeps

followed by the verbal warning message “FIRE!” This pattern

is repeated until the smoke is eliminated. The red LED light will

flash while in alarm/voice mode.

CARBON MONOXIDE: The alarm/voice pattern is four short

alarm beeps followed by the verbal warning message

“WARNING! CARBON MONOXIDE!". This continues until the

unit is reset or the CO is eliminated. While powered by battery

only, after four minutes the alarm/voice pattern will sound

once every minute. The red Light Emitting Diode (LED) light will

flash while in alarm/voice mode.

LOW BATTERY: If the battery is low, the red LED light will flash

and the unit will “chirp” one time, followed by the warning

message “LOW BATTERY.” This alarm contains a sealed 3V

Lithium battery, which will last the life of the alarm. No need

to replace batteries. This cycle will occur once every minute and

will continue for at least seven days. Under battery power, the

"LOW BATTERY" voice only occurs once every 15 minutes.

• Voice Message System that alerts user to the following

conditions:

– Only for smoke alarm Hush

System announces “HUSH MODE ACTIVATED” when

the unit is first put into HUSH Mode.

– Only for smoke alarm Hush

Features

2550-7201-00(i12010SCO)_V7a.qxd:_ 2013.11.28 9:57 AM Pag