Use and Care Manual

Alarm Removal
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the “OFF” arrow on the cover.
Battery (Non-Replaceable)
If any form of battery failure is detected the red LED light will
flash and the unit will “chirp” one time, followed by the warning
message “LOW BATTERY”. This cycle will occur once every
minute, and will continue for at least seven days. On battery
power, the "LOW BATTERY" voice occurs once every 15 minutes.
Replace alarm immediately!.
THE UNIT MUST BE DEACTIVATED (see “Deactivation of
Alarm” section) and replaced within 7 days of the first
occurrence of the “Low Battery Warning” to provide
continuous alarm protection.
If the red LED light flashes along with a chirp every 30
seconds, as described above, and if the green LED flashes
twice per second (AC power only) your unit has
malfunctioned.
Call our toll free Product Support Line at
1-800-880-6788 for instructions on how to return the unit.
End of Life Notification
Ten (10) years after unit is first powered, this alarm will beep two
times every 30 seconds to indicate it is time to replace the alarm.
REPLACE IMMEDIATELY! End of Life Hush can be activated
by pushing the test button to silence the End of Life chirp
for approximately 3 days at a time for a maximum of 30
day life extension.
Battery Information
21
2550-7201-00(i12010SCO)_V7a.qxd:_ 2013.11.28 9:57 AM Pag