User Guide

Battery Installation and Replacement
To install or replace the batteries in this Kidde CO alarm, please perform
the following steps.
1. Slide open the bottom cover to expose the battery compartment.
2. If replacing batteries, remove the old batteries and properly dispose
of them as recommended by the battery manufacturer.
3. Install the new batteries. Note the polarity
illustration in the battery compartment.
4. Close the bottom cover. Note: The bot-
tom cover will not close if all three AA
batteries are not installed.
When replacing the batteries, use one of
the following approved brands:
• Duracell MN1500 or MX1500
• Energizer E91
• Gold Peak 15A
• Golden Power GLR6A
These batteries can be purchased where you bought the alarm or at a
local hardware store. Use of a different
battery may have a detrimental effect on the alarm operation.
IMPORTANT: Constant exposures to high or low humidity may reduce
battery life. A good safety measure is to replace the battery at least
once a year, or at the same time as you change your clocks for daylight
saving time.
After installing or changing the batteries, reinstall your alarm. Test
your alarm by using the Test/Reset button and check that the green LED
flashes once approximately every 30 seconds.
4. Installation Instructions
Battery Polarity
for the three AA batteries
+
+
-+
-
-
2529-7209-01(21008094C).indd 122529-7209-01(21008094C).indd 12 13-3-12 上午11:5613-3-12 上午11:56