SDS

Safety Data Sheets (SDSs)
Report No.: ZRLK1506060004 Page 7 of 10
Protective gloves
Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
Penetration time of glove material:
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
Respiratory Protection No protective equipment is needed under normal use conditions. If exposure limits
are exceeded or irritation is experienced, ventilation and evacuation may be required.
Hygiene Measures Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical
State
Form: Solid
Color: Black
Odour: Monotony
Odor Threshold: No information available
Change in condition:
pH, with indication of the concentration
Not determined.
Melting point/freezing point
Not determined.
Initial boiling point and Boiling range:
Not determined.
Flash Point
Not determined.
Evaporation rate
Not determined.
Flammability (solid, gas)
Not determined.
Upper/lower flammability or explosive limits
Not determined.
Vapor Pressure:
Not determined.
Vapor Density:
Not determined.
relative density:
Not determined.
Solubility in Water:
Not determined.
Solubility in other solvents
Not determined.
n-octanol/water partition coefficient
Not determined.
Auto-ignition temperature
Product is not self-igniting.