User's Manual

ATTENTION! The model SL177 and SL177i strobe lights are designed to notify hearing
impaired individuals of impending danger, they have no detection means and MUST be
used in conjunction with operating Smoke, Heat, or Carbon Monoxide Alarms.
The model SL177i AC wire-in Strobe light can be directly interconnected with Kidde
Safety 3-wire Smoke, Heat and CO alarms. It will produce an intermittent flash pattern
(approximately 4 flashes, followed by approximately 5 seconds off) when triggered by a
Carbon Monoxide alarm and a steady flash when triggered by a smoke or heat alarm.
The model SL177 is a 2-wire device that can be used to add strobe light capabilities to
existing alarm systems produced by other manufacturers. A relay module or suitable
switching device ( not included), which is compatible with the alarm system will be
needed to energize the strobe light. Consult the alarm manufacturer to obtain the prop-
er switching device for your specific alarm model.
Thank you for purchasing this strobe light. It is an important part of your family’s home
safety plan. You can trust KIDDE Safety to provide the highest quality safety products.
We know you expect nothing less when the lives of your family are at stake.
For models: SL 177i and SL 177
P/N 810-1779 Rev. B
Strobe
Light
For your convenience, write down the following information. If you call
our Consumer Hotline, these are the first questions you will be asked.
Strobe Light Model Number
(located on back of alarm):
Date Code (located on back of device):
Date of Purchase:
Where Purchased:
SL 177 SL 177i
Strobe Light User’s Guide