Cut Sheet

Worry-Free Bedroom Smoke Alarm
Sealed Lithium Battery Power with Safety Light
Model P3010H
Architectural and Engineering
Specifications
The smoke alarm shall be Kidde unit P3010H or approved
equal. It shall be powered by a non-replaceable lithium battery
with 10-year life. The lithium battery shall be sealed in the unit
to prevent removal and/or tampering. The unit shall incorporate
a photoelectric sensor. The temperature operating range shall
be between 40ºF and 100ºF (4ºC and 38ºC) and the humidity
operating range shall be 10%-85% non-condensing relative
humidity.
The smoke alarm can be installed on the surface of any wall or
ceiling following the UL/Manufacturer’s approved placement
guidelines. The alarm shall incorporate an automatic activation
feature that will activate the unit as soon as it is attached to the
mounting bracket, no other steps are involved.
The alarm shall include a safety light that shall be powered by
lithium battery. The safety light shall provide 15 minutes of light
when the alarm is sounding. The alarm shall include a test but-
ton that will electronically simulate the presence of smoke and
cause the unit to go into alarm. This sequence tests the unit’s
electronics, battery and horn to ensure proper operation.
The unit shall include a piezoelectric horn that is rated at 85dB
at 10 feet. The unit shall include Smart Hush™ feature that
silences the unit for approximately 10 minutes if a nuisance
condition occurs.
The unit shall indicate a low battery condition with a brief alarm
chirp and LED flash once every 30 seconds. In standby condi-
tion, the LED will flash every 60 seconds for the first 10 minutes
following power on or test, and once every 10 minutes thereaf-
ter. It will also flash every 10 seconds while in Hush mode.
The smoke alarm shall include an End of Life Alert, where ten
years after initial power-up the unit shall chirp two times every
30 seconds to indicate the alarm needs to be replaced. The
End of Life indication can be silenced three days at a time for a
maximum of 30 days. The unit shall have a deactivation switch
to disable it and make it safe for disposal.
The unit shall at a minimum meet the requirements of UL217,
NFPA 72 (chapter 11 2002 edition), The State of California Fire
Marshall, NFPA101 (One and two family dwellings), Federal
Housing Authority (FHA), Housing and Urban Development (HUD).
It shall also include a 10-year manufacturer’s limited warranty.
Ordering Information
Technical
Specifications
Model: P3010H
PowerSource: Sealed Lithium Battery
Sensor: Photoelectric
AudioAlarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
HumidityRange: 10%-85% non-condensing
relative humidity (RH)
Size: 5.22” in diameter x 1.6” depth
Weight: 1 lb.
Interconnects: No
Warranty: 10 year limited
5.22" 1.6"
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.Kidde.com
Distributed by:
P/N: KL-P3010H sheet rev. 03-2013
Part No: I 2 of 5 UPC
Pack Quan-
tity
Dimensions
(w” x d” x h”) Weight
Case/
Skid
Skid
Weight
21010167 100-47871-10058-0 0-47871-10058-3 3-PK (Clam) 7.25 x 1.75 x 11 1 lbs N/A N/A
21010069 100-47871-10069-9 0-47871-10069-9 6-PK (Box) 5.75 x 2 x 6.25 1 lbs N/A N/A