User's Manual

TM0081 Page 45 of 51 Issue 1.01
Figure 40: VegaNET Network External Wiring
6. Set the panel address switches, SW 1 & SW 2 located on the network card as shown on Table 18.
Panel 1 Panel 2 Panel 3 Panel 32
SW1,SW2 1,0 2,0 3,0 0,2
Table 18: Panel Address Settings
7. Ensure that the following software EPROMS are installed in the MCP and Network cards:
!
44782-K071 IC 9 = P28185-1xx
!
29-020527-001 IC 9 = P01180-1xx
8. Power up the system. Apply mains supply first followed by the stand-by battery.
Set-up
1. Using the panel menu structure, locate the option Serial Port 1. This can be found from the top-level
menu under:
Set → Standard features → Panel setup. Refer table 10.
2. Change the option to ‘MARS/VDS Network‘.