User's Manual

ManualsBrandsKidde Fire Systems ManualsSmoke AlarmKidde Fire Systems Kidde Fire Systems Smoke Alarm 57-120099-002

Effective: August 2013

K-87-027

Kidde XV™ Control System

P/N: 87-120099-002

FEATURES

• For Use in:

•WHDR

™

Commercial Cooking Fire

Suppression Systems

•IND

™

Industrial Fire Suppression Systems

• Pneumatic Release of up to 20 Agent Cylinders

• Two Discrete Mechanical Detection Lines

• Cylinder or Wall Mount

• Up to 400 ft. Mechanical Detection Cable

• Operates 2 Gas Valves

• Available 24 V Electrical Actuation

• Multiple Remote Release Options

• Rugged, Die-Cast Aluminum Body

• Tamper/Lock Port for Cover

• Easy to Install and Maintain

• UL & ULC Listed

• FM Approved for IND Systems

DESCRIPTION

The Kidde XV Control System is a compact, versatile unit

used to actuate agent cylinders on Kidde WHDR and IND

Pre-Engineered fire suppression systems. The control

head can be operated via:

• Two Distinct Automatic Mechanical Detection Lines

(fusible links or thermo-bulb links)

• Optional Electrical Solenoid

• Remote or Local Manual Mechanical Control

Upon actuation, the XV Control System discharges the

nitrogen System Cartridge, pressurizing the actuation

lines and System Valve Actuators (SVA) mounted on the

cylinder valve(s). The SVA(s) open the cylinder valve(s),

discharging the WHDR wet chemical or IND dry chemical

suppression agent. The XV can be mounted on a wall or

directly to an SVA mounted on the cylinder.

The XV Control System is UL and ULC Listed with

WHDR Wet Chemical and IND Dry Chemical Fire

Suppression Systems. The XV is FM approved with the

IND Dry Chemical Systems.

The XV comes ready to install, with three EMT

connectors, one System Valve Actuator (SVA), two

microswitches, one nitrogen System Cartridge, and one

nitrogen test cartridge.

Figure 1. XV Control System, P/N 87-120099-002

Summary of content (6 pages)

PAGE 1
Kidde XV™ Control System Effective: August 2013 K-87-027 P/N: 87-120099-002 FEATURES • For Use in: • • • • • WHDR™ Commercial Cooking Fire Suppression Systems • IND™ Industrial Fire Suppression Systems Pneumatic Release of up to 20 Agent Cylinders Two Discrete Mechanical Detection Lines Cylinder or Wall Mount Up to 400 ft.
PAGE 2
TECHNICAL DATA Table 1. Mechanical Cable Parameters for WHDR & IND Systems Max. Cable Length Max. Corner Pulleys Max. Detectors Max. Tee Pulleys Detection and Manual Release-to-Trip Line 1 200 ft. (60.96 m) 50 40 * Detection and Manual Release-to-Trip Line 2 200 ft. (60.96 m) 50 40 * Pull-to-Trip Remote Manual Release Line 100 ft. (30.48 m) 30 - 1* Mechanical Gas Valve Line 100 ft. (30.48 m) 30 - 1* XV Cable Line *Tee pulleys count as two Corner Pulleys.
PAGE 3
4. 5. 6. 7. When Control System is wall mounted, a minimum of 5 ft. (1.52 m) of 1/4-inch O.D. x 0.031-inch wall tubing shall be used in the overall actuation line. High pressure nitrogen tubing (P/N 87-120045-00X) may be used in place of copper tubing, not to exceed a maximum length of 30 feet (9 m). In every system, either single cylinder or multiple cylinder, a 1/8-inch NPT plug or vent check (P/N WK-877810000) shall be used in the outlet port of the last System Valve Actuator(s) in the actuation line.
PAGE 4
SYSTEM VALVE ACTUATOR (SVA), P/N 87-120042-001 A System Valve Actuator (SVA) must be mounted to every system cylinder valve assembly (see Figure 4). The SVA has ports for low profile tubing runs, and is also equipped with a spring loaded plunger that locks the piston in the discharged position, ensuring complete discharge of the cylinder(s) contents. 5/16-18 UNC THROUGH HOLE (TYP) (NOT SHOWN) 1/8 in. NPT PORT 1-3/4 in. (44 mm) 1/8 in.
PAGE 5
SOLENOID, P/N 83-100034-001 WIRE TYPE KEY An optional solenoid can be installed into the XV Control System, just under the actuation latch. The solenoid operates directly on the actuation latch to activate the system. This installation allows simultaneous usage of mechanical detection lines, or the lines can be locked out. The solenoid includes two mounting bolts, the bracket and a push plate which mounts onto the solenoid body (Figure 6). The solenoid coil is 24 Vdc at 1.5 Amp and at 70°F (21°C).
PAGE 6
ORDERING INFORMATION Description XV Control System includes: (1) 87-120042-001 System Valve Actuator (1) 87-120043-001 System Nitrogen Cartridge (1) 87-120044-001 Test Cartridge (1) 87-120058-001 EMT Connector Kit (1) 87-120039-001 Microswitch Kit (1) 87-120039-501 Microswitch Kit 87-120099-002 System Valve Actuator 87-120042-001 System Nitrogen Cartridge 87-120043-001 Test Cartridge 87-120044-001 High Pressure Hose for Cylinder Mount 87-120045-001 EMT Connector Kit 87-120058-001 Solenoid Electr