Smoke Alarm User Manual

Installation, Operation and Maintenance Manual
Issue 1 Page 4-7
February 2001
4.5.1 Installing the Remote Display Module
The Remote Display Module back box is designed for surface mounting and should be mounted before
assembly. The back box is fitted to the wall using four mounting screws. To allow communications
between the Display Module and the Detector a 4-core screened cable is required, recommended Mineral
Insulated Copper Cable (MICC) or Belden 9729 screened twisted pair. This will connect between the
termination board and the terminals positioned within the Display Module. To mount the Remote Display
Module proceed as follows:
(1) Remove the Display Module from its carton and carry out a visual inspection of the unit to
ensure that no damage has occurred during transit.
(2) Remove the screw located at the bottom of the Display Module, remove back box.
(3) Place the back box in location (wall or conduit box) mark and drill the wall. Secure the
unit with the appropriate hardware.
(4) With the back box securely fitted in position connect cable to the appropriate terminations
of the Display Module. Ensure that the connections are correct and secure.
(5) Place the Display Module onto the back box and secure with the screw at the bottom of
the module.