Patent: 5,890,320 KidCo is a member of: User Guide Made in Denmark for: KidCo, Inc. 300 Terrace Drive Mundelein, IL 60060 Patents pending www.kidco.com Phone 847-970-9100 Fax 847-970-9109 Bl. 3001-101d • G70-0208 HearthGate Model G70 For hearths 6’ wide by 2’ deep Optional 8” section (G70-8) or 24” section (G70-24) available for larger areas.
Important Notes FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE Before attempting to unfold the gate, read instructions thoroughly. Failure to do so may result in damage to the gate or injury to your child. Your HearthGate™ is completely assembled and folded compactly and must be unfolded in sequence.
Unpacking 1. 2. 2. 1. 3. 2a. Down Hinge Assembly Unpack your folded HearthGate™ on a stable surface, making sure handle is on top. Each corner is connected by plastic, interlocking hinges. 5. How to adjust the sections: A spring is fitted in all cones which deliberately creates tension when adjusting. At corner, lift up slightly on section with hinge teeth facing down (1) while gently pressing down on connected section (2). Rotate sections to desired position. (3). Release to lock into place.
Assembly 9. Installation Remove hinge cap (H) from bottom of original end section. A screwdriver may be needed to pry it off. Place under bottom hinge. Remove plastic cone from under top hinge of original end section. Install cone (I) under top hinge of new end section. 13. Reinstall a removable, vertical bar. Insert bar by pressing it into upper hinge cone, while sliding bar into groove of lower hinge. Spring in cone will make bar lock in place. Proceed to ”Installation” steps 13 to 23. 14.
Installation 17. a b c Buttons Center buttons of assembly with wall plate holes (17. a). When aligned, push buttons through holes and slide down to lock (17. b & c). Installation 21. Remove wall plate (C) from assembly by pressing locking tab (21a.) and lifting it off. 21a. C Now it should look like this. 18. Note: Screws provided are for mounting directly into wood. If mounting into brick, drywall or other surfaces, use appropriate hardware. 22.
Operation Opening the walk through door: 25. Squeeze handle up as much as possible (1). The locking bar should release from bottom frame (2). Door can now swing open in either direction. 1. Closing and locking the walk through door: While closing door, squeeze handle up as much as possible (25.1.) and align bottom of door with gate frame (25.2.). Release handle and door should lock. Gate should always be in the locked position. 26.
