Owner's Manual
6 7
Assembly
Follow the assembly steps in the order listed below.
❶ Aach the an-pping bracket.
Working from the underside of the
Zero-Turn ride-on:
• Place the an-pping bracket
into the bracket inset on the
underside of the mower body
• Slide the axle through the
gearbox's and an-p bracket
• Fasten with 2 an-p bracket
screws (packed in the
hardware bag)
❷ Make the wire connecon.
• Connect the wires from the
underside of the mower with
the wires coming from the
mower blade assembly
• Feed the excess wire back into
the mower blade assembly
❸ Aach the mower blade assembly.
• Remove the washers and nuts
from the threaded pegs on the
underside of the mower body
• Place the large washer over the
pegs on the underside of mower
blade assembly
• Insert the pegs on the top of the
mower blade assembly down
into the pegs of the mower body
• Re-fasten the washers and nuts
back onto the threaded pegs.
❹ Aach the steering levers.
Gently roll the Zero-Turn ride-on
right side up to complete the
remaining steps.
• Insert each control lever
down into the lever brackets
• Align the holes in the control
lever with the holes in the
brackets.
• Fasten with the bolt and nut
❶
❸
Tip
❷
Steps 1–3 shown from the underside
of the Zero-Turn ride-on.
Use a needle-nose
pliers to hold the
nut in place while
fastening the bolts.
❹
Tip
To allow the rear axle to
slide through the an-p
bracket. Ensure the holes
in the gearbox's align
with the holes in the
an-p bracket.