User Manual

6 7
Assembly
Follow the assembly steps in the order listed below.
❶ Remove the nut and bolt from the
front axle. Rotate the front axle
completely around unl it meets
the opposite side.
❷ Rotate each axle out and fasten the
nut and bolt back into place.
❸ Insert the front fenders onto each
front axle, and secure with 2 screws.
❹ Aach the le and right front wheel
assembly to each front axle.
❺ Insert the rear axle completely
through the gearbox.
❻ Fit the rear fenders over each rear
gearbox and fasten with 3 screws.
❼ Aach the le and right rear
wheel assembly to the rear axle.
❽ Insert the steering column up
into the axle and secure with the
washer and nut.
❾ Place the handlebars over the
steering column and secure with the
nut and bolt.
Note: Insert two AAA baeries
into the baery compartment
on top of the handlebars.
❿ Before you attach the seat make the
one-time battery connection.
(See page 8).
⓫ Place the seat over the baery
compartment and lock into place
⓬ Charge the baery. (See page 9)
❹
❺
Insert the hubcap
tabs into the 4 slots
on the wheel inset.
To ghten the wheel bolts, place a
wrench on each wheel bolt and
simultaneously turn the wrenches in
the opposite direcons unl the
bolts are ght.
❿
⓫
Remove the nut and bolt
from the steering wheel
BEFORE performing Step 6.
Baeries are
not included
❻
❻
❼
❼
❹
❾
⓬
❸
❸
❶
❷
Hold the steering column ght
against the under-body while
aaching the handlebars.
❽