User Manual

6 7
Assembly
Follow the assembly steps in the order listed below.
❶ Remove the nut on the right side of the front
axle and rotate the front axle assembly
completely around unl it is facing towards the
center of the body.
❷ Insert the steering column into the axle and
secure with the washer and nut. Rotate each
axle unl it is facing outwards and fasten the
nut back onto the axle assembly.
❸ Insert the rear axle completely through the
rear of the rear axle opening in the wheel well.
❹ Aach the le and right rear wheel assembly to
the rear axle.
❺ Aach the le and right front wheel assembly
to the front axle.
❻ Insert the mirrors down into each mirror hole.
❼ Connect the steering wheel wires before
inserng the steering wheel over the end of the
steering column. Secure with nut and bolt.
❽ Insert the tabs of the windshield down into the
holes located on the top of the Ford body.
❾ Insert the rollbar down into the rollbar holes.
❿ Before aaching the seat make the one-me
baery and gearbox connecon. (See page 8.)
Place the seat boom over the seat cavity and
secure with the 2 screws.
⓫ Slide the seat back down into the seat brackets
on each side, and t the boom tabs down into
the seat boom and secure with 2 screws.
⓬ Charge the baery. (See page 9.)
Be sure the gearbox and
wires are completely
inserted through the
gearbox opening.
❶ ❷
Insert the hubcap
tabs into the 4 slots
on the wheel inset.
❼
❻
To ghten the wheel bolts, place a
wrench on each wheel bolt and
simultaneously turn the wrenches
in the opposite direcons unl
the bolts are ght.
❽
❿
⓫
❾
❹
❹
❺
❺
❸
Steering column inserted
with nut and washer
Completely align the holes in
the steering column with the
holes in the steering wheel.
Hold the steering column ght
against the under-body while
aaching the steering wheel.