User Manual

6
Assembly
Follow the assembly steps in the order listed below.
❶ Make one-time battery connection and 3-pin saddle
connector located under the saddle. (See Page 8).
❷ Unscrew the bolt from the horse’s neck.
❸ Aach the wires in the head to the connector in the
neck.
❹ Place the head on the neck and align the bolt holes.
TIP! Look through the nut hole and move neck around
unl you see daylight to conrm alignment before
inserng bolt.
❺ Insert the bolt into the circular hole in the neck.
Screw the bolt in completely.
❻ Put the saddle horn on the saddle and screw on ghtly
using a Phillips screwdriver. Snap the saddle horn
cover on.
❼ Thread the saddlebag straps down through the holes
closest to the seat, and then up through the holes
closest to the outside edge of the saddle. Aach the
hook-and-loop tape.
❸
❷
❺