User Manual

CAUTION!
Re-Charge Interval and Time
Important!
• Damage to the baery may occur if it is allowed to drain completely. Do not allow the baery to drain completely.
• Check the baery and charger (supply cord, connector) for wear and damage before charging. Do not charge the baery if
damage has occurred. Do not use an extension cord when charging the ride-on toy.
• On average you will need to charge the baery between 10 and 14 hours Do not charge the baery for more than 24 hours.
Failure to charge the baery as directed could cause permanent damage to the baery and void the warranty.
• Only an adult who has read and understands the safety warnings should handle, charge and recharge the baery.
If you are unsure of any informaon in this manual or have a queson regarding assembly or use please call customer service.
Always keep this manual for reference and include it with resale of the ride-on toy.
Pre-Ride Safety Checklist
(To be performed by a supervising adult)
Before every ride, it is important to carry out the following safety checks. Do not ride a baery powered ride-on toy that is not in
proper working condion! Replace any worn or broken parts as needed.
Steering and Control
The steering wheel or handlebars are ghtened and secured in the mount or dashboard.
The steering wheel or handlebars are posioned so that the rider can easily operate and steer the ride-on. There must be no
diculty for the rider in turning and/or operang the powered foot pedal or hand operated push buon.
The steering wheel or handlebars are aligned so that the steering column and front wheels are oriented in the same direcon.
Wheels
The wheels are securely aached to the baery powered ride-on and the are in good condion. It is acceptable to have slight
lateral movement in each wheel.
The wheels have no holes or are worn down in any one area and that the tracon strips are intact and secured to the wheels.
The drive wheel is securely fastened to the gear box, which houses the motor.
Ride-on
For all electrical components, make sure:
• The baery is fully charged
• The charging cord is NOT aached to the ride-on in any way
• All connectors are securely snapped in place and will not come detached while riding
• No wiring is exposed, worn, or detached in any way; the motor is not hot to touch
• All electrical buons, including the power buon, accelerator foot pedal or hand operated buon, and any buons for
lights and sounds, work properly
• If the ride-on’s electrical components show any sign of damage or missing parts DO NOT RIDE unl the condion is
corrected
Make sure the ride-on is:
• Clean, dry, and in good condion
• All plasc pieces, including fenders, seat, footrests, steering wheel or handlebars, wheels, bumpers, and/or hub caps are
securely aached
• There are no cracks or structural problems on the ride-on toy
• If the ride-on toy shows any sign of damage or missing parts DO NOT RIDE IT unl the condion is corrected
Make sure all safety labels are in place and readable, and understood by the rider.
3