User Manual

Aach the Rollbar
4. Route the wire connector coming from
the boom of the rollbar down into the
rollbar hole, through to the connector
under the truck bed.
5. Push the four posts on the boom of
the rollbar into the four holes in the
truck bed unl they snap into place.
Aach the Rear View Mirrors
1. Insert the mirror into the
pin of the mirror bracket
on the RAM body.
2. Insert the long (1½”)
screw through the hole
into the bracket.
3. Fasten by placing the
small nut on the end of the
screw, and ghten the nut.
Aach the Baery and rollbar
to the Motor
6. Aach the two blue baery
connectors. Note: You will only need
to connect the baery to the motor
one me.
Only use the KidTrax toys 12V charger
included with the RAM 3500 (Input:
AC 120V, 60Hz Output: DC 6V).
7. Aach the rollbar connectors.
Note: You will only need to make
this connecon one me
12
1
2
4
5
3
6 7