User Manual

Aach the Doors
1. Orient the doors so the interior of the
door is facing the interior of the car.
2. Insert the post on the boom of the
door into the hole on the side of the
car body.
3. The hinge should t into the hinge
inset. Align the holes on the hinge
with the hinge inset.
4. Insert a screw into each hole on the
door hinge and ghten.
There will be a total of four screws.
Aach the Dashboard
1. Aach the wire connectors coming
from the dashboard body (located
in the dashboard inset) to the wire
connectors coming from the boom
of the dashboard.
2. Insert the three tabs on the front of
the dashboard into the three slots on
front of the dashboard inset.
3. Align the holes on each side of the
dashboard with the holes on the sides
of the dashboard inset.
4. Insert a screw into each hole and
ghten. There will be a total of
two screws.
It’s easiest to perform the next steps
when the doors are open.
Tip!
10
1
4
1
2
2
2
3 3
4
4
3
2