User Manual

Note: There is a total of eight of screw locations

Aach the Rear Wheels

1. Slide the rear wheel onto the end of the axle, ng the back of the

rear wheel into the gear box.

2. Insert a washer over the axle. Using the included hex wrench, fasten

the nut on the end of the axle and ghten. The axle may need to

be shied le or right to be evenly distributed so the res to t

properly.

3. Align the four tabs of the hubcap with the slots in the front of the

wheel and press into place.

4. Repeat steps 1-4 on the opposite rear axle.

Check to make sure the

motor is placed under

the square tubing before

aaching the wheels.

Tip!

Aach the Grill Assembly

1. Carefully turn the grill assembly (grill

and bumper) upside down.

2. Slide the grill assembly towards the

truck body and fasten by:

a. Inserng the tube coming from the

grill assembly into the tube coming

from the front axle.

b. The square brackets on the grill

assembly should t into the

brackets at the front of the body.

c. The holes on the grill assembly

should overlap the holes in the

front body. Fasten the screw from

the top of the grill assembly.

d. Insert the screws through the screw

brackets into the screw

hole on the grill assembly.

3. Insert a screw into the tube and fasten

ghtly.

cc c c