Instruction Manual

2021 - present F150 CrewCab XLT and SuperCab XLT
Page 6 of 24 AMML3J19A014AA © Copyright Ford 2021 FoMoCo
VML3Z18808A
Contact KICKER
® Technical Support at [phone] ext. 6009, or [e-mail].
Using a pick tool, slide the terminal retainer
out on both sides until it stops.
Find locations 11, 22, and 23 in the
connector housing and verify they are not
populated. If these locations are populated,
discontinue installation and verify system
compatibility.
Insert the terminals into the connector
housing.
NOTE: Terminals will not lock into housing
if they are not orientated correctly. If the
terminal does not lock into housing, flip the
terminal 180 degrees and re-insert.
Location 11 – White Wire
Location 22 – Black Wire
Location 23 – Purple Wire
Press terminal retainer back into the locked
position.
B-Pillar Trim Panel Removal - SuperCrew
NOTE: Removal steps in this procedure may
contain installation details.
Lower B-Pillar Trim Panel
Remove the front door scuff plate trim
panel.
1. Release the clips and remove the
front door scuff plate trim panel.
2. If equipped. Disconnect the
electrical connector.
Release the clips and remove the rear door
scuff plate trim panel.
23
11
22
Terminal Orientation