Instruction Manual

2021 - present F150 CrewCab XLT and SuperCab XLT
Page 10 of 24 AMML3J19A014AA © Copyright Ford 2021 FoMoCo
VML3Z18808A
Contact KICKER
® Technical Support at [phone] ext. 6009, or [e-mail].
NOTE: It is only necessary to make a cut
indicated by the dotted line to allow the
vertical portion of the brackets to protrude
through carpeting.
NOTE: Cuts must extend to the rear edge of
carpet.
Make measurements from the center of the
seatbelt stud and from the back wall. Cut
the carpet and insulation to allow it to lie
over brackets once installed.
Install bracket. Torque: 46 lb.in. (5.2Nm)
Lower the subwoofer into position aligning
the plastic fastener with bracket hole.
Install bolt. Torque: 46 lb. in. (5.2 Nm)
Install supplied retainer around harness at
the position marked with blue tape. Trim
the excess length of the retainer. Attach the
retainer over the stud.
NOTE: Screws and metal retainers are pre-
installed in upper bracket and designed to
snap into sheet metal as assembled. Do not
remove screws or metal retainers during
installation.
115mm
115mm
327mm
Front of
Vehicle
338mm
Razor Knife
X2