Owner's Manual

9

38. Remove the two screw clips and screws from the replacement subwoofer mounting bracket.
(These are only used for trucks not originally equipped with subwoofers)
39. Connect the subwoofer harness four pin connector to the subwoofer and engage the red locking
tab by sliding sideways. Next connect the subwoofer harness ten pin connector to the
subwoofer, engage the red locking tab and then attach the connector to the bracket as shown in
Fig. 29
40. Secure the replacement subwoofer in place with the supplied bolts and with the factory amplifier
bracket screws removed earlier. Fig. 27
41. Reinstall all previously removed parts in reverse order.
42. Install supplied fuses into fuse holders.
43. Reconnect negative battery cable.
Fig. 27
Fig. 26