Owner's Manual



Fig. 22

Fig. 20

Fig. 25

Fig. 24

Fig. 21

32. Remove the passenger side factory subwoofer mounting stud. Fig. 20

33. Remove the four screws securing the factory amplifier to its bracket. Fig. 21

34. Install the factory amplifier on the relocation bracket using the supplied nuts (X2) and bolts (X2).

Make sure the nuts are installed on the amplifier side as shown in Fig. 22

35. Cut the carpet section indicated in Fig. 23 and remove to allow the amplifier relocation bracket

to install.

36. Install the amplifier relocation bracket underneath the driver’s side rear seat as shown in Fig. 24

Line up the holes in the amplifier relocation bracket with the holes formally used to secure the

factory subwoofer and factory amplifier bracket.

37. Install the factory amplifier bracket bolt removed earlier in the hole farthest from the driver’s side

and tighten while keeping the other hole centered. Fig. 25 The replacement subwoofer

mounting bolt (supplied) will occupy the other amplifier bracket hole. Reconnect amplifier

wiring.

Fig. 23

1½”