Owner's Manual
5
19. Connect the subwoofer harness four pin connector to the subwoofer and engage the red locking
tab by sliding sideways. Next connect the subwoofer harness ten pin connector to the
subwoofer, engage the red locking tab and then attach the connector to the bracket as shown in
Fig. 9
20. Set the subwoofer in place and line up the screw clips in the upper bracket with the rectangular
holes in the back of the cab. Push against the bracket and snap the screw clips into the sheet
metal. Fig. 10 Note: There is no need to loosen the screws unless you need to remove
the subwoofer for some reason.
Fig. 10
Fig. 9
Fig. 8
2½”
2”
3½”
5”