Owner's Manual



Fig. 4

Power Harness Routing

1. Disconnect negative battery cable.

2. Make sure supplied fuse is not installed in fuse holder and connect the subwoofer power wire to

the stud pictured in figure 1.

3. Route the power harness toward and along the firewall and secure with supplied wire ties.

4. Make a small incision in the grommet on the driver side of the firewall and pass the power

harness into the cabin. Fig. 2

5. Install the black two pin power connector on the subwoofer power harness. Note: Make sure

the blue retainer in the center of the connector body is not depressed. If the retainer is

depressed, the terminal will not fully seat in the connector body. Make sure the terminal

is installed into position 1 on the connector body. There should be a block-out plug

installed to prevent the terminal from being installed into the wrong position on the

connector body.

Subwoofer Harness Routing

6. Pull loose the dash end trim panel on the driver’s side of dash. Fig. 3

7. Connect the black ground wire of the subwoofer harness to the bolt above the driver’s kick

panel. Fig. 4

Fig. 1

Fig. 2

Fig. 3