Owner's Manual

3
Fig. 6
9. Connect the subwoofer harness two-pin power
connector to the power harness two-pin
connector.
10.Find the gray and black connector in the drivers
kick panel and carefully cut the fabric loom from
the wire harness. Find the twisted pair of wires
that are light blue and brown/light blue stripe.
Install the supplied wiretaps onto the wires.
Fig. 6
11.Connect the green wire of the supplied adaptor
harness to the light blue wire and the brown wire
of the adaptor harness to the brown/light blue
stripe wire.
12.Connect the adaptor harness to the subwoofer harness.
13.Ground the subwoofer harness to the bolt securing the left side of the dash. Tighten to 19Nm
(14ft-lb) Fig. 7
14.Route the subwoofer harness along the driver side door openings. Pull harness under carpet
and through hole near rear seat frame on the driver side. Fig. 8
15.Connect the subwoofer harness to the subwoofer.
16.Push down firmly on the subwoofer to slide it under the rear seat frame. Make sure the
subwoofer bracket is fully installed over the nut insert in the rear seat frame. Install the supplied
foam pieces along the front of the subwoofer enclosure where indicated in Fig. 9
17.Reinstall the rear seat frame trim panel over the subwoofer enclosure and reinstall the bolts and
bumpers. It may be necessary to make slight adjustments to the subwoofer enclosure or rear
seat trim panel position to perfectly center the enclosure. Reinstallation of the two filler panels
on each side of the seat frame trim panel is possible, but not necessary. Fig. 10
Fig. 7
Fig. 8
Fig. 10
Fig. 9
Foam pads