Owner's Manual

Fig. 4

Power Harness Routing

1. Disconnect negative battery cable.

2. Make sure supplied fuse is not installed in fuse holder and connect the subwoofer power wire to

the stud pictured in figure 1. Tighten to 4.7Nm (42in-lb)

3. Route the power harness toward the firewall and secure with supplied wire ties.

4. Make a small incision in the grommet on the driver side of the firewall and pass the power

harness into the cabin. Fig. 2

5. Install the black two pin power connector on the

subwoofer power harness by first inserting the

terminal fully into the connector and then

depressing the blue retainer. Fig. 3

Note: Make sure the blue retainer in the

center of the connector is not depressed – it

should be flush with the front of the

connector. If the retainer is depressed, the

terminal will not fully seat in the connector

body. Make sure the terminal is installed into

position 1 on the connector body. There should be a block-out plug installed in position

2 in order to prevent the terminal from being installed into the wrong position on the

connector.

Subwoofer Harness routing

6. Remove the driver side front and rear threshold panel along the bottom of the door opening.

7. Remove the filler panel on each side of the rear seat frame trim panel. Fig. 4

8. Remove the eleven bolts and rubber bumpers securing the rear seat frame trim panel and

remove the trim panel from vehicle. Fig. 5

Fig. 5

Fig. 1

Fig. 2

Fig. 3

Insert

terminal

first

Then

depress

blue

retainer