Owner's Manual

Remote Bass Level Control
When using the Remote Bass Level Control you have the ability to control the
level of the subs from the driver’s seat. To mount the controller simply screw the
metal bracket to the chosen location, then slide the housing onto the bracket
until it snaps into place. Run the cable from the controller to the appropriate
jack on the amplifier chassis.
The use of twisted pair interconnects is recommended for all installations to
minimize noise. When routing these cables through the automobile, try to keep
them away from factory wiring harnesses and other power wiring. If you need to
cross any of this wiring do so at a 90 degree angle to reduce the potential of
noise problems.
When working with power connections it is always recommended that you dis-
connect the battery to prevent accidents.
The ground should be connected to the amplifier first before making any of
the other connections. This wire should be as short as possible (24 inches or less)
and connected to a paint/corrosion free solid metal area of the car’s chassis. Use
the same gauge wire as recommended for the amplifiers power connection to
the battery. Adding an additional ground wire between the car battery’s negative
post and the car chassis of this same gauge (or larger) is also recommended. If
you ever need to remove the amp from the vehicle after it has been installed,
the ground wire should be the last wire disconnected from the amplifier, just the
opposite as when you installed it.
A fuse must be installed within 18 inches of the battery to protect the power
wire feeding your amplifier. This fuse should be of at least the same value used
in the amplifier but no higher than the capacity of the wire. See the chart below
for wire size and fusing recommendations.
Model Fuse Size Wire Size
KX-550.3 60A 4 GA
KX-700.5 90A 4 GA
REMOTE BASS
LEVEL CONTROL
PHONE
CABLE
KX550.3 KX700.5
OR
Mounting Surface
Back View
REMOTE
BASS
+ - - +
AMP 1
L
AMP 1 INPUT
R
+
L
AMP 2 INPUT
R
L
SUB AMP INPUT
R
4