Owner's Manual

5
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to send the
incoming signal from one Kicker KX series amplifier to another amplifier or
processor without the need for Y cables. The signal from the PAST jacks is iden-
tical to the signal fed to the amplifier via its RCA input jacks or the High Level
inputs and is not affected by the amplifier’s built in crossover.
Most head units with high voltage outputs should be capable of driving up to
ten amplifiers in a chain.
Remote Bass Level Control
When using the Remote Bass Level Control you have the ability to control the
level of the subs from the driver’s seat. To mount the controller simply screw the
metal bracket to the chosen location, then slide the housing onto the bracket
until it snaps into place. Run the cable from the controller to the appropriate
jack on the amplifier chassis.
When using more than one KX.1 amplifiers you have the ability to control all of
them from one Remote Bass Level Control. The adapter is a common Modular
phone splitter found at Radio Shack and is installed between the controller and
the amplifier.
SOURCE UNIT
Left +
Left -
Right -
Right +
Speaker
Outputs
RCA
Outputs
WARNING-Use Only One...Never Both At The Same Time !!!
L
INPUT
R
+ -
L
OUTPUT
R
SPEAKER OUT
REMOTE BASS
HI-LEVEL
INPUT
SUB
SONIC
FILTER
+ - - +
ON
OFF
L
INPUT
R
+ -
L
OUTPUT
R
SPEAKER OUT
REMOTE BASS
HI-LEVEL
INPUT
SUB
SONIC
FILTER
+ - - +
ON
OFF
To Next Amplifier
REMOTE BASS
LEVEL CONTROL
Mounting Surface
Common Modular
Phone Splitter
To Other
Amplifiers
OUT IN
AMP STRAPPING
OUT I
N
AMP STRAPPING