Owner's Manual

11English
Midrange/Tweeter Mounting
The midrange/tweeter is flush-mounted and may be
installed using one of the included adapters: Toyota/
Subaru, Chrysler/Jeep, GM/Mopar. Choose a flat
location on the panel with space behind the panel
to allow room for the motor structure, and tweeter.
After checking the clearances, cut a 1-3/4” (44mm)
diameter mounting hole in the panel. If using an
adapter, place the adapter against the surface. Feed
the wire through the adapter and the hole in the
panel. Secure the driver by screwing the supplied
screws onto the tweeter.
Toyota/Subaru
Chrysler/Jeep
GM/Mopar