Owner's Manual

11. Plug the blue wire on the kicker harness into the switched power harness lead with one wire.
a. This allows for an accessory 12V port to remain available.
12. Route both power leads along the left side of the neck and through the electrical caddy to the seat area.
13. Reconnect the battery terminals.
SYSTEM SETUP
Note: At this time, it is highly recommended to set the amp gain to 0. KICKER recommends that the dip switches be set up as follows:
Auto turn-on - 12V Input level - HI HI-PASS – 80 Hz Input Gain control – 0
14. Plug the radio in, but do not reinstall it until the gain has been set.
15. Test component function and set the gain to optimize system performance.
16. Carefully reassemble the motorcycle and enjoy your new audio system!
NOTE: These two leads are amplifi ed and non-amplifi ed speaker outputs with auxiliary switched power. They are intended to provide ease of
installation for speaker lid speakers or other add-on audio. Fig 13.
KICKER cannot be held responsible for any damage to painted surfaces during removal or addition of KICKER parts.
FHDR15-B-20180326
1
2
3
4
5
6
7
8
9
10 11 12
13