Owner's Manual

KLOCK
WERKS
I FLHT KICKER
AMP AND SPEAKER
INSTALLATION (CONTINUED)
WIRE ROUTING
1.
Take the electrical
harness
and plug
it
into
the
amplifier
2.
Following the color code, route the left and right side
speaker
wires safely to their respective
speakers
(Pic 1)
3.
Plug
in
the
male
ends
into the stock harness,
the
terminals removed during
speaker
installation
(Pic 1)
-
4.
Plug the female
ends
onto the
speaker
terminals
(Pic 1)
5.
Locate the headlamp
harness
and remove the red cap over the Orange/White wire.
a.
If
that wire
__
is
currently
in
use (e.g. accessory lighting]
there
is an additional piggy back connection on
the
Kicker
harness
to replace
it
6.
Plug the blue wire from the Kicker
harness
into
the
Orange/White wire, making
sure
it
is fully engaged.
(Pic 2)
7.
Whether the extra blue wire lead
is
being used or not, heat shrink has been provided
to
put over
it
to reduce the risk
of
a short.
(Pic 5)
8.
Follow the proper procedure to remove
the
fuel tank.
9.
Remove
the
electrical caddy lid.
10.
Route the power
harness
on the left side
of
the frame neck, lay
it
into that caddy and
under
the
seat.
(Pic 3 &
4)
a.
You
may want
to
remove the fuse now while figuring out wire placement.
11.
The blue lead
under
the
seat
would be used
if
installing a second amplifier, but again,
whether
used or not,
cover with heat shrink to reduce the risk
of
a short.
(Pic 5)
12.
Connect the battery terminals, install fuse and check audio system operation.
Note:
At
this time,
it
is highly recommended to follow
the
guidelines
in
your Kicker
PX
100.2
owner's
manual
to
set
up
the
amplifier. Klock Werks
recommends
that the dip switches be
set
up
as
follows:
1.
Auto turn-on -
12V
2.
Input
level-
HI
3.
HI-PASS-
OFF
4.
Input
Gain
control-
Follow the instructions
in
your Kicker
PX
100.2
owner's
manual
Pg. 4
13.
Be
sure
to check
that
none
of
the wires will be
in
a bind when the steering head
is
turned
fully to the right or the left.
14.
Disconnect negative battery terminal and carefully
reassemble
motorcycle.
15.
Reconnect negative battery terminal, install
seat
and enjoy your Kicker audio system!