Owner's Manual

Step 4: Partially install the swivel lever, adjusting it to be loose (open) when the lever is parallel to the
tube, then finish tightly securing the swivel lever
to the enclosure using the included thumbscrew. When
the swivel lever is locked in place, or closed, the bracket rotation assembly will be clamped tight.
swivel lever
thumbscrew
swivel lever
®
Step 5: Extend the speaker and LED wiring through the hole you have drilled and connect them to your
source unit
or amplifier. KICKER recommends you solder the connections and secure them with heat
shrink.
When hard-wiring the RGB lighting, the black lead
is+ 12V and the red, green, and blue leads are
ground. Splice and combine the ground wires
to yield a different color. There are seven colors available,
depending on your wiring configuration. KICKER recommends using the KMLC lighting controller (sold
separately) for more colors, patterns, and special effects.
Black: +12V
Red: Ground
Green : Ground
Blue : Ground
Transparent Blue : Speaker
+
Transparent Gray : Speaker -
4
c ___ ~ o ____ ()
t