Owner's Manual

8
In this confi guration, the Front Row is used to drive your tweeters, midrange/midbass drivers and subwoofers
separately; each with their own amplifi er, crossover points and time alignment. Use this confi guration with a set of
components that require active crossovers and independent time alignment.
Set the FRONT FREQUENCY switch to a factor of X10 and adjust the HI-PASS crossover for tweeter use
(Recommended starting point of 3KHz).
Confi gure the REAR/SURROUND channel for mids by using the crossovers as a band-pass fi lter. Set the LO-
PASS switch to ON and the FREQUENCY switch to a factor of X10, then adjust both the HI-PASS and LO-PASS
crossovers accordingly (Recommended starting points of 80Hz and 3KHz, respectively).
Adjust the SUBWOOFER channel’s
LO-PASS crossver to 80Hz.
This confi guration allows you to time
align your left mid/mid-bass speaker
and left tweeter separately for
an optimal driver’s-side listening
experience. You will not be able to
use the Surround Sound function
and it should be turned OFF.
Once the crossovers and OUTPUT
LEVEL controls on your Front Row
are confi gured, use the remote
control to fi ne-tune the sound.
INPUT
GAIN
MIN MAX
10 500Hz
50 500Hz 40 160Hz0° 180°
10 500Hz
10 80Hz
MIN MAX MIN MAX MIN MAX
MIN MAX
MIN MAX
OUTPUT
LEVEL
OUTPUT
LEVEL
LO-PASS
X-OVER
HI-PASS
X-OVER
HI-PASS
X-OVER
SUBSONIC
PHASE
FREQUENCY
dB/OCT
LO-PASS
CLIP LIMITER
CLIP LIMITER
DC OFFSET/12V
CLIP LIMITER
OFF/ON
OFF/ON
OFF/LO
OFF/ON
TURN-ON
FREQUENCY
48/24/12
48/24/12
48/24/12
1X 10X
1X 10X
dB/OCT dB/OCT
LO-PASS
X-OVER
OUTPUT
LEVEL
INPUT CLIP
POWER
FRONT
REAR/SURROUND
SUBWOOFER
INPUT
GAIN
INPUT
GAIN
INPUT CLIP INPUT CLIP
High, Mid and Low wiring
factory source unit /
factory amplifi er
Front Row
full-range signal
sub channel
high-channel
(tweeters)
mid-channel
2 or 4-channel
full-range amplifi er
2 or 4-channel
full-range amplifi er
subwoofer amplifi er
fullsub
2012 FrontRow (ZXDSP) Rev G.indd 82012 FrontRow (ZXDSP) Rev G.indd 8 4/30/2012 1:55:50 PM4/30/2012 1:55:50 PM