ZX SUBWOOFERAMPLIFIER CLASS-DMONOCHANNEL ZX1000.1, ZX1500.1, ZX2500.
3. Configuration The following diagram shows the most common configurations for your Kicker ZX series amplifier. ZX.1SeriesAmplifier Owner’sManual MonoChannel: ZX1000.1 / ZX1500.1 / ZX2500.1 One Channel Operation These ZX amplifiers are capable of operating into a minimum impedance of 2 ohms. If you are using multiple voice coils, the net impedance of the voice coils must be equal to or greater than 2 ohms.
RED Badge Light on, no output? Check the following: 1) RCA connections 2) Test speaker outputs with a “known” good speaker. 3) Substitute source unit with a “known” good source unit. 4) Check for a signal in the RCA cable feeding the amplifier with the VOM meter set to measure “AC” voltage. Operation AUTO TURN ON +12V DC AUDIO OFFSET SPKR + INPUT LEVEL L LO HI R L R End Panel LED flashing with loud music? The yellow LED indicates low battery voltage.
ElectronicsLimitedWarranty Kicker warrants this product to be free from defects in material and workmanship under normal use for a period of THREE (3) MONTHS from date of original purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for TWO (2) YEARS from date of original purchase with receipt. In all cases you must have the original receipt.
