Owner's Manual

KX Amplifiers

Installation

System Diagrams

The following diagrams show the most common configurations for your Kicker KX series system.

Stereo Operation with Subwoofer

These KX amplifiers are capable of operating into a minimum impedance of 2 ohms per channel in stereo operation and 2 ohm

mono on the subwoofer channel. Modern high performance speakers have a lower DC Resistance than what used to be available.

The Kicker Coaxial and Component Speakers are rated at four ohms (some DC Resistances may be as low as 3 ohms) and work

with any amplifier designed to operate at a four ohm load. If you want to use two Kicker Coaxial or Component Speakers on a single

channel of your amplifier wire the speakers in series. This will improve the sound quality, lower the total harmonic distortion and

lessen the thermal load at the amplifier. This may prevent an amplifier from shutting down, due to over-current protection circuitry.

KX700.5

GROUND

REMOTE

TURN-ON

BATTERY

+12V

FUSE

18"

or less

SIGNAL IN AMP 1

SIGNAL IN AMP 2

+- + -

SIGNAL IN SUB

(Optional)

AMP 1

+- + -

AMP 2

SUB

2 Ohm minimum impedance

One pair of 4 Ohm Speakers or

two pairs of 4 Ohm Speakers

wired in series is recommended.

2 Ohm minimum impedance

One pair of 4 Ohm Speakers or

two pairs of 4 Ohm Speakers

wired in series is recommended.

2 Ohm minimum impedance