Installation Sheet

5
ASSEMBLY INSTRUCTIONS
2. Wire connection guide:
Ground wire:
• For installation in the United States:
Wrap
ground wire from outlet box around ground
screw preassembled on mounting bracket (B)
no less than 2 in. from wire end. Tighten
ground screw. If fixture is supplied with a
ground wire, connect to outlet ground wire
with a wire connector (AA).
• For installation in Canada: If fixture is
supplied with ground wire, wrap ground wire
around ground screw on mounting bracket
(B). Tighten ground screw. Connect fixture
ground wire to outlet ground wire with a
wire connector (AA).
Supply wires:
• Connect the Neutral (White) supply wire from
the outlet box to the Neutral fixture wire
(White or Parallel Cord “D” shaped and
ribbed).
• Connect the Hot (Black) supply wire from the
outlet box to the Hot fixture wire (Black or
Parallel Cord round and smooth).
NOTE:
Fixture wires will either be:
• Black and White.
• Parallel Cord SPT-1 lamp wire with
one round smooth wire and one “D”
shaped ribbed wire.
Hardware Used
x 3Wire Connector
AA
2
BARE COPPER,
OR GREEN
GROUND
SUPPLY WIRE
BARE COPPER,
OR GREEN
GROUND
FIXTURE
WIRE
BLACK FIXTURE
WIRE
OR
WHITE FIXTURE
WIRE
BLACK SUPPLY
WIRE
BLACK SUPPLY
WIRE
PARALLEL
FIXTURE CORD
(ROUND AND
SMOOTH)
PARALLEL FIXTURE
CORD (“D” SHAPED
AND RIDGED)
WHITE SUPPLY
WIRE
WHITE SUPPLY
WIRE
AA
3. Insert short machine screws (CC) into
mounting bracket (B) leaving half the
threads exposed. Raise canopy (A) to the
short machine screws and push over to lock
into the keyholes. Finish tightening the short
machine screws (CC) until they are snug
against the canopy (A).
Hardware Used
x 3
Canopy
Screw
CC
3
CC
A
B