Installation Sheet

Date Issued: 04/12/16 IS-49739-US
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
1) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF”
position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the “OFF” position.
2) Slip fixture over post and mark position of mounting holes in
post.
3) Remove fixture from post.
4) Drill 3/16” dia holes in post at positions marked .
5) If fixture is provided with ground wire, connect fixture
ground wire to outlet box ground wire with wire connector.
Never connect ground wire to black or white power supply
wires.
6) Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a
hole and two raise dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Put
ground wire from outlet box under cupped washer and
green ground screw and thread screw into hole in
mounting strap. If fixture is provided with ground wire.
Connect fixture ground wire to outlet box ground wire
with wire connector after following the above steps.
Never connect ground wire to black or white power
supply wires.
7) Make wire connections. Reference chart below for correct
connections and wire accordingly.
8) Slip fixture over post and secure in place using provided
screws. Screws should slip into holes drilled in post.
9) Insert recommended bulbs (Not included).
10) Set roof down on top of glass/trim.
11) Thread screws down through holes in roof and into holes in
glass/trim. Tighten screws to secure roof in place.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
ROOF
TECHO
SCREWS
TORNILLOS
CANDLE
SLEEVE / SOCKET
MANGA DE
VELA / TOMA
DE CORRIENTE
MOUNTING
SCREWS
TORNILLOS
DE MONTAJE
WIRE NUTS
TUERCAS
DE MARIPOSA
BULB
(NOT INCLUDED)
BOMBILLA
(NO INCLUIDO)