Installation Guide

5) Make wire connections (connectors not provided). Reference
chart below for correct connections and wire accordingly.
6) Push fixture to wall. Place canopy of fixture over tabs on
mounting bracket.
NOTE: Be certain wires do not get pinched between canopy
and mounting strap.
7) Thread screw into hole on top of canopy. Tighten screw to
secure fixture in place.
8) Raise glass up to fixture passing hole in glass over socket.
9) Slip spacer over socket and screw socket ring onto socket.
(DO NOT over tighten.)
1) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF”
position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the “OFF” position.
2) At the center of the mounting strap are knockout slots.
Remove the set that matches your outlet box.
3) Attach mounting strap to outlet box. NOTE: The mounting
strap should be positioned so the angled tab is on the top of
the mounting strap.
4) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a
hole and two raised dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector
(not provided.) after following the above steps. Never
connect ground wire to black or white power supply wires.
GREEN GROUND
SCREW
CUPPED
WASHER
A
B
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
(NOT PROVIDED)
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth)
*Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 8/21/15 IS-45193-US
GLASS
VIDRIO
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
MOUNTING STRAP
PLANCHA PARA MONTAR
SPACER
ESPACIADOR
SOCKET RING
ANILLO DEL CASQUILLO
SCREW
TORNILLO
ANGLED TAB
LENGÜETA EN ÁNGULO
CANOPY
ESCUDETE
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.