Installation Sheet

CAUTION – RISK OF SHOCK – Disconnect Power at the main
circuit breaker panel or main fuse box before starting and
during the installation.
1) Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
2) Attach mounting strap to outlet box. (Screws not provided).
Mounting strap can be adjusted to suit position of fixture.
3) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a
hole and two raised dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector
(not provided.) after following the above steps. Never
connect ground wire to black or white power supply wires.
4) Make wire connections (connectors not provided). Reference
chart below for correct connections and wire accordingly.
5) Push fixture to ceiling, carefully passing mounting screws
through holes in canopy. NOTE: Be certain wires do not get
pinched between mounting strap and canopy.
6) Use ball knobs and lockwashers to secure canopy. Tighten to
secure.
7) Carefully raise glass to the fixture. Slip the smaller opening
over the socket and fit the glass against the glass trim.
8) Raise the steel plate into the glass and then align the holes to
fit over the support studs.
9) While holding the steel plate to the glass, thread the lock-up
knobs onto the studs. Tighten to secure the glass into place.
(DO NOT OVER TIGHTEN).
10) Insert recommended bulb. (Not supplied)
Date Issued: 8/30/17 IS-44066-US
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
BULB (NOT INCLUDED)
BOMBILLA (NO SE INCLUYE)
OUTLET BOX
CAJA DE SALIDA
WIRE CONNECTORS
CONECTORES DE ALAMBRE
(2) LOCK-UP KNOBS
PERILLAS DE SUJECIÓN
STEEL PLATE
PLACA DE ACERO
GLASS
VIDRIO
SOCKET
PORTALÁMPARAS
(2) LOCK-UP KNOBS
PERILLAS DE SUJECIÓN
(2) LOCKWASHERS
ARANDELA DE SEGURIDAD
CANOPY
ESCUDETE
(2) STRAP MOUNTING SCREWS
TORNILLOS DE MONTAJE DE LA ABRAZADERA
MOUNTING STRAP
ABRAZADERA DE MONTAJE
(2) MOUNTING SCREWS
TORNILLO DE MONTAJE
SUPPORT KNOBS / PERILLA DE APOYO
GLASS TRIM
GUARNICIÓN DE CRISTAL