Installation Guide

PACKAGE CONTENTS
2
A Shade
O-Ring
Thumbscrew
Bulb
B
C
D
1
2
1
1
PART DESCRIPTION QTY.
Socket Assembly
Ground Stake
Quick Connect
E
F
G
1
1
1
PART DESCRIPTION QTY.
• O-rings (B) should not be
removed from the
fixture.
• If O-rings (B) should
come out clean and
reinstall them into the
grooves where they
originated from.
1.
Insert bulb (D) into socket
found on the socket assembly
(E).
2. Slide shade (A) over the socket
found on the socket assembly
(E) and secure with
thumbscrew (C).
G
F
1A
F
G
A
E
D
B
C
3. Determine desired location for
mounting fixture.
• At desired location, hammer stake (F) into
ground. To avoid damage to stake, place a
board on top of stake while hammering. If
ground is hard and stake is difficult to install,
make a crosscut in ground using a flat
shovel.
• Clear away area in ground at wireway slot in
top of stake (F). Lay fixture’s 12V cable into
wireway slot and screw socket assembly (E)
into stake (F). If assembly does not look
straight, adjust by pushing or pulling on stake
only. (See figure 1A).
• TURN OFF POWER. Connect fixture’s 12V
cable to transformer landscape wire run using
supplied wire connector.
• Silicone lubricant has
been provided to to
assist with intalling
O-Rings (B).