Phau Ntawv Qhia

10 11
Detached remote setup
Push to detach
remote control
from PSU
You can detach the remote from the PSU and
use it without any drawbacks in sound quality.
This is perfect when you have a separate control
and recording room. The connection works via
standard XLR cable and is compatible with your
patchbay (maximum cable length is 150m / 492ft).
If transformers are in the signal path, the
communication between the remote and PSU will
not work. Polarity inversion however is not a
problem.
If you use a half-normalled patch bay, make sure
to insert a cable in the patch-point in the row
below. Otherwise the remote will not receive the
necessary operating voltage.
Tip: If you are not certain if the remote is properly
connected, check the 'Remote' LED on the PSU.
Connect the microphone to the PSU via the
10-pin cable. Connect the PSU to the remote via
standard XLR cable.
Turn on power and check all status LEDs.
Preamp, interface or mixing console