Phau Ntawv Qhia

6 7
Connectors
Mix
Outputs the mixed
signal set via the Circuit
control: Fully clockwise
provides 100% tube,
fully counterclockwise
100% FET.
Preparing the microphone for recording
Sleep
Hold to put the system
into sleep mode/wake
it up.
Logo light
Tap to activate/
deactivate the
logo light on the
microphone.
Remote
Connect a standard
3-pin XLR cable to
use the remote in the
detached setup.
Not needed in the
stacked setup.
Microphone
Connect the
microphone via the
included 10-pin cable.
Mount the shock mount onto a stable microphone
stand. Open the fixture of the shock mount. Put
the tube microphone in the shock mount. The
tube window indicates the default front. Lock the
fixture.
Attach the pop filter from below. You will feel when
the magnet snaps it into place.
Connect the microphone to the PSU via the 10-pin
cable. Flip the power switch on the PSU. Check
the status LEDs and wait until 'Operational' stops
blinking.
Now, the microphone system has reached its full
sensitivity and you are ready to record.
FET
Outputs the pure FET
signal independently
from the setting on the
Circuit control setting.
The low-cut and
attenuation settings will
still affect the signal.
Power
Turn the system on/off.
Open