Phau Ntawv Qhia

4 5
Settings and indicators
Tube
Change the tube characteristic.
• Clear: Tube works at technical optimum.
• Warm: Smooth and pleasant high-end.
• Dark: Tamed highs for bright sources.
• Saturated: Rich harmonics and subtle
compression.
Filter
Set the low-cut filter to fit your needs.
Attenuation
Set the right attenuation for your recording
situation.
Circuit
Blend between tube and FET circuit. This ratio will
be sent to the Mix output.
Pattern
Set your polar patterns seamlessly. The notches
indicate standard polar patterns.
LEDs on remote
Power: Indicates that the system is turned on. The
LED turns red in Sleep mode.
Microphone: Microphone is connected.
Operational: Ready to use when the LED is steady.
Blinking indicates that the system needs a few
seconds to be fully operational (after starting up,
changing the pattern, setting attenuation, etc).
LEDs on PSU
Power: System receives power. Red in Sleep.
Remote: Remote is connected.
Microphone: Microphone is connected.
Release button
Press to detach the remote from the PSU. If
properly stacked, remote and PSU hold firmly
together. A click mechanism confirms this.
Default / Reverse
Define which side is set as the front of the
microphone. Default indicates the tube window is
set as the front. Reverse sets the logo as the front.
Default Reverse