LCT 1040 Manual Check out the setup video. lewitt-audio.
Contents About the LCT 1040 About the LCT 1040 ......................................................................................... 1 The LCT 1040 is a microphone system with a The LCT 1040 is a studio condenser microphone • Gold-sputtered 1" true condenser capsule What’s included ................................................................................................ 2 comprehensive set of options to dial in the perfect using both, FET and tube circuitry.
What’s included Magnetic pop filter to reduce plosives Tube microphone with Get your popcorn ready and simply scan the code to open the setup video. Register your product and extend your warranty to 10 years for free. 1" true condenser capsule lewitt-audio.com/lct-1040-setup Shock mount that reduces low-frequency rumble and structure-borne noise Front Back Side Remote control to set lewitt-audio.
Settings and indicators Tube LEDs on remote Change the tube characteristic. Power: Indicates that the system is turned on. The • Clear: Tube works at technical optimum. LED turns red in Sleep mode. • Warm: Smooth and pleasant high-end. Microphone: Microphone is connected. • Dark: Tamed highs for bright sources. Operational: Ready to use when the LED is steady.
Connectors Preparing the microphone for recording Mount the shock mount onto a stable microphone Sleep Remote stand. Open the fixture of the shock mount. Put Hold to put the system Connect a standard the tube microphone in the shock mount. The into sleep mode/wake 3-pin XLR cable to tube window indicates the default front. Lock the it up. use the remote in the fixture. detached setup. Logo light Not needed in the Attach the pop filter from below.
Stacked remote setup Standard XLR cable The LCT 1040 consists of three parts: the microphone, the PSU, and the remote. The remote is attached to the PSU by default (no cable needed). Connect to your preamp, Connect the microphone via the 10-pin cable. audio interface, or mixing console On the right side, you can see how to wire all parts for the stacked remote setup.
Detached remote setup You can detach the remote from the PSU and Connect the microphone to the PSU via the use it without any drawbacks in sound quality. 10-pin cable. Connect the PSU to the remote via This is perfect when you have a separate control standard XLR cable. and recording room. The connection works via standard XLR cable and is compatible with your Turn on power and check all status LEDs. patchbay (maximum cable length is 150m / 492ft).
FAQs When is the system fully operational? The 'Operational' LED on the remote indicates that the system is ready to use. Once it stops blinking, the microphone has reached full sensitivity. Please note Do I need to hang the mic upside What kind of tube is inside? down due to the heat coming After months of testing, we settled on the from the tube? E88CC / 6DJ8 from JJ Electronics. We tested it. There is no audible difference. Just position it the way you prefer.
If you have any further questions, please get in touch. We look forward to hearing from you. lewitt-audio.
