Owner's manual

ENGLISH
Chapter 4: Using the DVR
DVR User’s Manual
51
Formang USB drive
To format the USB disk drive, do the following:
1 Plug a USB device into the USB connector at the front panel or the rear panel of the device.
2 In preview mode, right-click on the mouse to display the Pop-up menu.
3 Select Main Menu > DEVICE > HDD.
4 Click Format USB.
5 An “All data will be deleted aer formaed” warning message appears on the screen. Click OK to proceed.
6 When the formang process is complete, click OK.
Note:
Do not remove the USB device while drive formang is in progress.
4.4.2 Seng Alarms
On the alarm menu, you can congure the alarm type, enable buzzer, set the buzzer me, set up the email alarm
nocaon, and other related alarm nocaon sengs.
Congure Alarm Sengs
To set up the alarm seng, do the following:
1 In preview mode, right-click on the mouse to display the Pop-up menu.
2 Select Main Menu > DEVICE > ALARM.
3 Select the channel to set the alarm.
4 If an I/O alarm device is connected, select YES in I/O Status.
5 Click Apply.
6 When data saving is complete, click OK.
« TIP »
To copy the current sengs to other channels, select the channel, then click Copy.
7 Click Alarm Conguraon.