Owner's manual

ENGLISH

Chapter 4: Using the DVR

DVR User’s Manual

4.2.2 PPPoE

The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulang Point-to-Point Protocol (PPP)

frames inside Ethernet frames.

1 In the preview mode, right-click on the mouse to display the Pop-up menu.

2 Select Main Menu > NETWORK.

3 On Type, select PPPoE.

4 Specify the Media Port and WEB Port numbers.

5 Enter the username (an email address) and password.

6 Specify the DNS Server1/Server2 IP address.

7 Aer all sengs are complete, click Apply.

8 When data saving is complete, click OK.

Note:

The system supports two DNS server input opons: DNS Server1 for main server and DNS Server2 for sub server.

Please contact your local ISP (Internet Service Provider) to obtain the correct DNS Server parameter.

4.2.3 Stac IP

This opon allows you to congure the network interface using a xed IP address.

1 In preview mode, right-click on the mouse to display the Pop-up menu.

2 Select Main Menu > NETWORK.

3 On Type, select Stac IP.

4 Specify the Media Port and WEB Port numbers.

5 Specify the stac IP address, Netmask, Gateway, and DNS Server1/Server2 IP addresses.