Owner's manual

ENGLISH

Chapter 2: Installaon

DVR User’s Manual

Chapter 2: Installaon

2.1 Installing the Hard Disk Drive

Depending on the package you have purchased, the hard disk drive may be included in the full package. If it is not

pre-installed, follow the installaon instrucons on this user manual.

DO NOT install or remove hard disk drive while the device power is turned on.

2.1.1 Installing HDD on 4-Channel / 8-Channel DVR

The 4-channel / 8-channel DVR supports one 3.5” SATA hard disk drive. To install the HDD, follow the steps below.

Note:

The illustraons below show an 8-channel DVR, same procedures apply to a 4-channel DVR.

1 Loosen the screws in the le, right, and rear sides as

shown.

2 Push back then li up the cover to remove it.

3 Connect the data and power cables to the hard disk

drive (HDD).

4 Aach the HDD to the bracket using 2 screws.

5 Aach the cover and the screws back in place.