Manual

ENGLISH

Chapter 2: Installaon

DVR User’s Manual

2.1.2 Installing HDD on 16-Channel DVR

The 16-channel DVR supports up to two 3.5” SATA hard disk drives. To install the HDD, follow the steps below.

5 Aach the bracket back to the compartment using

four (4) screws.

6 Connect the data cables to the hard disk drive (HDD).

7 Connect the power cables to the hard disk drive (HDD)

and the DVR.

8 Aach the cover and screws back in place.

1 Loosen the screws on the le, right, and rear sides as

shown.

2 Push back then li up the cover to remove it.

3 Detach the screws to remove the HDD bracket.

4 Aach the HDD to the bracket using the four (4)

supplied screws.