Owner's manual

ENGLISH
Chapter 5: KGUARD Web Client
DVR User’s Manual
95
Menu Item Descripon
Enable Select Enable to issue a nocaon when the event type occurs.
Buzzer Set the buzzer duraon when the event occurs ( O/10 S/20 S/40 S/60 S).
To disable buzzer, select O.
Show Message Check the box to display a message on the screen when the event occurs.
Send Email Check to enable email alarm nocaon. If the funcon is enabled, the system will
send the alarm to the specied email address. See “4.6.2 PTZ Setup” on page 54.
Alarm Out If an alarm device is connected, check the box to make the device sound the alarm
when the event occurs.
Latch Time Select the alarm duraon (10S/20S/40S/60S).
4 Aer all sengs are complete, click Save.
Set Auto Maintenance
Use this feature to automacally reboot the DVR on a specied schedule. When the DVR reboots, all sengs and data
are refreshed from the memory, which opmizes the DVR performance.
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Advanced > Maintain.
3 Set Auto Maintain to Enable.
4 In Reboot, select the frequency to reboot the DVR. Opons are:
• Everyday: Reboots the DVR on a daily basis. If this opon is selected, specify the me you want to reboot the
DVR.
• Every Week: Reboots the DVR on a weekly basis. If this opon is selected, specify the day of the week and the
me to reboot the DVR.
• Every Month: Reboots the DVR on a monthly basis. If this opon is selected, specify the date (1 to 31) and the
me to reboot the DVR.
Note:
The illustraon above is an example of Auto Reboot set to Every Week. The available elds vary depending on the
selected Reboot opon.
5 Aer all sengs are complete, click Save.
« TIP »
To restore the maintenance schedule to default seng, click Refresh.