Owner's manual

ENGLISH
Chapter 4: Using the DVR
48
DVR User’s Manual
5 Aer all sengs are complete, click Apply.
6 When data saving is complete, click OK.
Note:
To apply for a free DDNS account, refer to the informaon on the “SUPPORT” page from our website
(www.kguardsecurity.com).
4.4.4 Email Sengs
The DVR supports sending of email nocaons when events occur, such as when moon is detected or the HDD fails,
etc.
Note:
Be sure that the DVR network connecon is properly congured before proceeding with the email setup.
To set up email, do the following:
1 In preview mode, right-click on the mouse to display the Pop-up menu.
2 Select Main Menu > NETWORK, select the Email tab.
3 On Email, select Enable.
4 On SSL, select the Enable check box if your email server needs the SSL vericaon. Check with your email service
provider for the applicable seng.
5 Enter the SMTP port and SMTP Server of the sending email server, the email address and password of the sender in
Sender and Sender PWD respecvely.
Note:
By default, the SMTP port is 25 for email without SSL vericaon. For Gmail server or for email that needs SSL
vericaon, the SMTP port is 465, by default. Check with your ISP for the correct seng.
6 In Receiver Email, enter the email address where the email alarm is to be sent. In Interval, select an email sending
interval.
7 Aer all sengs are complete, click Apply.
8 When data saving is complete, click OK.
9 Aer all sengs are complete, click Apply.
10 When data saving is complete, click OK.